What I did today...

[zoidberg]

after 2 days of scrutineering duties at Eastern Creek, today I got back to a work in progress.... turning up a new steering neck shaft for a custom frame with a Honda front end.


Needed to make a custom button die holder as I didn't have one to hold the button die to suit the M24x1 and M26x1 button die.
long story short.... all critical sizes done and first thread cut. (this one holds the top tree in place...) Material - 4140 (CrMo)

20151206_183331.jpg

next step is to cut the second thread that pulls against the bearings. Then its a turn around to finish the lower end.

Will post a few shots once complete...


Cheers

Little Mick

My god that must be satisfying making your own bits and pieces you need! Top work!

[Little Mick]

My god that must be satisfying making your own bits and pieces you need! Top work!

Cheers Zoids. Yeah it has a sense of satisfaction . This one isn't for me though, but satisfying none the less.

Sent from my SM-N9005 using Tapatalk