Jan 26 - Aus Day - Ride Day

[Krackeye]

It's a fucking dogs breakfast. T5 you have to ride 2m off the apex to avoid the bumps.
I haven't been here since November St George and t1 is considerably worse. Will have to redo 5 for sure.
On the up side I'm doing similar times to the last race weekend. That's unheard of from me. Normally need some red mist. 😡🏁


Sent from my iPhone using Tapatalk

[Marshy]

It's a fucking dogs breakfast. T5 you have to ride 2m off the apex to avoid the bumps.
I haven't been here since November St George and t1 is considerably worse. Will have to redo 5 for sure.

I think I'm gonna cry. I had such high hopes for the T1 resurface. And T5 was always fine, so it's gonna be a pain if it's now not.

[Condor]

Well I only wish I could have an opinion about them corners today…

First lap, coming into turn 6, the little rod that connects the break leaver to the master cylinder some how came off, leaving me with absolutely no
front break, and no choice but to ditch the bike in the kitty litter to avoid the oncoming concrete wall.

Speeeee Uwin. Bikes ok…., Im ok so apart from the waste of a ride day… all good.

Last ride I had a low side turn 9 mid corner. I Replaced the damaged break lever and checked time and time again all was ok.
Looks like in that incident that rod became a little loose and then vibrated free today.

[Turbo]

Well I only wish I could have an opinion about them corners today…

First lap, coming into turn 6, the little rod that connects the break leaver to the master cylinder some how came off, leaving me with absolutely no
front break, and no choice but to ditch the bike in the kitty litter to avoid the oncoming concrete wall.

Speeeee Uwin. Bikes ok…., Im ok so apart from the waste of a ride day… all good.

Last ride I had a low side turn 9 mid corner. I Replaced the damaged break lever and checked time and time again all was ok.
Looks like in that incident that rod became a little loose and then vibrated free today.

Damn man, shitty day!! Glad yer all good tho mate.

[Krackeye]

Well I only wish I could have an opinion about them corners today…

First lap, coming into turn 6, the little rod that connects the break leaver to the master cylinder some how came off, leaving me with absolutely no
front break, and no choice but to ditch the bike in the kitty litter to avoid the oncoming concrete wall.

Speeeee Uwin. Bikes ok…., Im ok so apart from the waste of a ride day… all good.

Last ride I had a low side turn 9 mid corner. I Replaced the damaged break lever and checked time and time again all was ok.
Looks like in that incident that rod became a little loose and then vibrated free today.

I saw you just as you were picking it up. No good mate.