that's awesome!
would you be able to tool something like this?
$T2eC16JHJF8FFp9DsYo3BSTorw7)5!~~60_12.JPG
minus the M/C
that's awesome!
would you be able to tool something like this?
$T2eC16JHJF8FFp9DsYo3BSTorw7)5!~~60_12.JPG
minus the M/C
Andrew,
the closer I look, the more I work out... now that I worked out what it is ( Mr Ed. )....
assuming your clip ons are below your trees....What is your fork diameter below your clip on? (need to go below the taper on the tube to a parallel section - hopefully its within 50mm or so from the clip on......)
If clip ons are above trees, do you have 12mm of parallel below trees?
do you have a MC sorted? of so what are the CL dimensions of the mounting holes and the outside diameter of the master?
cheers
Mick
Last edited by Little Mick; 14-10-2013 at 08:06 PM.
Life's too Short- YOLO!
There are currently 24 users browsing this thread. (0 members and 24 guests)
Bookmarks