Saturnalian
20-04-2018, 04:03 PM
{SOLD}2014 YZF-R6 Race Bike (08) frame
Lovingly built from the ground up between March and June 2014.
Some of you know this bike. You can research the build thread here....
http://www.tarmactalk.com/forum/showthread.php?548-Clubsport-Build-Finally
This bike was completely stripped and sent to Laurie Alderton for straightening
All bearings were replaced and every component painstakingly inspected and cleaned as new.
The engine was methodically rebuilt from scratch by Ian Irving from YRD.
Higher compression, cam timing, YEC Parts.
Everything is carefully lock wired and still in fantastic condition.
This bike has seen less than 10 (slow) days on track since completion.
Someone should RACE this. I’ve not the time. It’s a weapon.
Offers around $11k. PM me for further info
Engine/ Fuelling
YEC Clutch kit and springs
Woodcraft engine cases with Stainless steel skid pads
GB Racing engine covers
Driven Block off plates
BMC Air Filter
Dynojet PCV and SFM with all 8 injectors carefully mapped
Powertech BSB Velocity stacks, optimised at 13,200rpm.
2014 YEC ECU and YEC wiring Harness
Akrapovic Racing line stainless headers and titanium canister
MAC Radiators Add-on Racing Radiator
Samco Race Hose kit
Shorai Lithium battery- Rock solid.
Frame
2008 stat. Frame
DB Holders Lightweight Subframe
Motoholders Race Fairing Stay
Vortex V3 Rearsets
Graves R6 Diamond Frame sliders
Custom Race seat with Graves seat foam and Sergeants quick release pins
Fast Frank Racing captive rear caliper bracket and axle guide
Fast Frank Racing GP stand lifters
Woodcraft shark guard
Bodywork / Suspension / Wheels
Ohlins NIX 30 Carts with Zenodamper internals
Ohlins TTX Shock with Zenodamper internals
Ohlins SD020 Steering Damper kit
Racers Edge fairings, vinyl wrapped in Matte Metallic Blue
Wet4u Racing Carbon / Kevlar tank protectors
Custom Race seat with Graves seat foam and Sergeants quick release pins
Carbon Fibre front and rear fenders, sprocket cover, mounting brackets.
Sandblasted and powder coated wheels with Fast Frank Captive spacers
RK GXW Chain - Driven sprocket kit 45/15.
Titanium- axle nut, fork pinch bolts, triple clamp pinch bolts, top yoke bolts, rotor bolts
Electronics / Controls
Race Technology Dash 2 w’ lap timing on Carbon fibre mount.
Race Technology DL1 data Logger inc. 20Hz GPS
Handlebar controls for YEC Map / Lap Marker / Pit Limiter
Dash inputs for Power Commander / YEC software
Dash controls for fans / Data Logger / Engine Run
Lightweight Starter switch block.
Riderlogic Custom wiring harness with inputs for Brake Pressure and suspension sensors
Pazzo Levers / Active Evo throttle kit / Graves Brake lever guard.
Translogic quick shifter
Brakes
Brembo RCS19 Master cylinder
Brembo Monobloc M4108 Calipers with tapered spacers
Braking SK2 directional front wave rotors
Braking lightweight rear rotor
Galfer Racing Lines, front and rear.
Spares
Yes…..
22552250225122522253225422562257225822592260
Lovingly built from the ground up between March and June 2014.
Some of you know this bike. You can research the build thread here....
http://www.tarmactalk.com/forum/showthread.php?548-Clubsport-Build-Finally
This bike was completely stripped and sent to Laurie Alderton for straightening
All bearings were replaced and every component painstakingly inspected and cleaned as new.
The engine was methodically rebuilt from scratch by Ian Irving from YRD.
Higher compression, cam timing, YEC Parts.
Everything is carefully lock wired and still in fantastic condition.
This bike has seen less than 10 (slow) days on track since completion.
Someone should RACE this. I’ve not the time. It’s a weapon.
Offers around $11k. PM me for further info
Engine/ Fuelling
YEC Clutch kit and springs
Woodcraft engine cases with Stainless steel skid pads
GB Racing engine covers
Driven Block off plates
BMC Air Filter
Dynojet PCV and SFM with all 8 injectors carefully mapped
Powertech BSB Velocity stacks, optimised at 13,200rpm.
2014 YEC ECU and YEC wiring Harness
Akrapovic Racing line stainless headers and titanium canister
MAC Radiators Add-on Racing Radiator
Samco Race Hose kit
Shorai Lithium battery- Rock solid.
Frame
2008 stat. Frame
DB Holders Lightweight Subframe
Motoholders Race Fairing Stay
Vortex V3 Rearsets
Graves R6 Diamond Frame sliders
Custom Race seat with Graves seat foam and Sergeants quick release pins
Fast Frank Racing captive rear caliper bracket and axle guide
Fast Frank Racing GP stand lifters
Woodcraft shark guard
Bodywork / Suspension / Wheels
Ohlins NIX 30 Carts with Zenodamper internals
Ohlins TTX Shock with Zenodamper internals
Ohlins SD020 Steering Damper kit
Racers Edge fairings, vinyl wrapped in Matte Metallic Blue
Wet4u Racing Carbon / Kevlar tank protectors
Custom Race seat with Graves seat foam and Sergeants quick release pins
Carbon Fibre front and rear fenders, sprocket cover, mounting brackets.
Sandblasted and powder coated wheels with Fast Frank Captive spacers
RK GXW Chain - Driven sprocket kit 45/15.
Titanium- axle nut, fork pinch bolts, triple clamp pinch bolts, top yoke bolts, rotor bolts
Electronics / Controls
Race Technology Dash 2 w’ lap timing on Carbon fibre mount.
Race Technology DL1 data Logger inc. 20Hz GPS
Handlebar controls for YEC Map / Lap Marker / Pit Limiter
Dash inputs for Power Commander / YEC software
Dash controls for fans / Data Logger / Engine Run
Lightweight Starter switch block.
Riderlogic Custom wiring harness with inputs for Brake Pressure and suspension sensors
Pazzo Levers / Active Evo throttle kit / Graves Brake lever guard.
Translogic quick shifter
Brakes
Brembo RCS19 Master cylinder
Brembo Monobloc M4108 Calipers with tapered spacers
Braking SK2 directional front wave rotors
Braking lightweight rear rotor
Galfer Racing Lines, front and rear.
Spares
Yes…..
22552250225122522253225422562257225822592260