PDA

View Full Version : Brake fluid on screen ???



thunderace
09-11-2016, 12:02 PM
Found this on the inside of the windscreen after ride at Eastern Creek on Monday. Could see any coolant leak, could this be brake fluid, How ???
Doesn't seem to want to come off very easy ???
Bike is Ducati 848 Evo Corse
Thanks

Stuart

Linden
09-11-2016, 01:58 PM
Not a huge panic it is oil - I've been there done that with my mhe - it's from the steering damper

thunderace
09-11-2016, 03:44 PM
Not a huge panic it is oil - I've been there done that with my mhe - it's from the steering damper
Thanks Linden

I'm assuming that means the damper stuffed ?
I'm guessing it's non-rebuildable too ?

Marshy
09-11-2016, 04:13 PM
It'll be a blown seal. Probably replaceable. Call Rob at Well Sprung Motorcycle Suspension, or PM him on here.

Linden
09-11-2016, 05:30 PM
I'm assuming that means the damper stuffed ?
I'm guessing it's non-rebuildable too ?

Mine was (but I didn't look hard for anyone else) I dislike steering dampers so just had it packed with grease and ignored it :)

thunderace
09-11-2016, 05:41 PM
I assume that the damper would filled with oil. what ever is on the screen won't come off. Almost feels like it had eaten into the plastic ?

Dunno
09-11-2016, 06:13 PM
I assume that the damper would filled with oil. what ever is on the screen won't come off. Almost feels like it had eaten into the plastic ?

Nasty stuff. Try eucalyptus oil on a rag. Give it a few goes.

thunderace
09-11-2016, 06:33 PM
That's what i tried. Did nothing
Do you mean the damper fluid is nasty or brake fluid
Should brake fluid be able to get out reservoir. i thought it was sealed ?

triumph
09-11-2016, 06:44 PM
yeh damper on my triumph is leaking a bit .

Marshy
09-11-2016, 07:13 PM
Do you mean the damper fluid is nasty or brake fluid

Damper fluid is just oil. It should just smear around and wipe off easily. Brake fluid is really nasty.... if you run out of paint stripper, brake fluid makes a good substitute. And it'll eat plastic easily enough, especially if it's old plastic and a bit brittle. Check the short hose between the brake master cylinder and the reservoir. It may be cracked, or they also often can weep a little bit under the hose clamp. I often need to add a small cable tie, and/or a turn of lockwire (not too tight - you don't want to cut through the hose) to each end.

Nelso
17-11-2016, 07:35 PM
I've had brake fluid on the inside of the screen before, when a master cylinder was leaking due to a bent piston after a crash.