PDA

View Full Version : Zx10r Woolich Launch Control settings



Leezx10r
13-02-2016, 04:53 PM
Hi guys.

Just wondering if there is anyone out there that runs the Woolich racing software, and will be willing to share their setting.

I have tried a few lower rpm launch settings with different ramp speeds, but not really had the chance nor location to test all day.

This is my next map to test, thoughts?

http://images.tapatalk-cdn.com/16/02/12/be1ba8ebc835aba146d7e027976ca7d5.jpg

The log data software is great btw.

http://images.tapatalk-cdn.com/16/02/12/a82e705dd9913ed4e27e0ec73f2889bd.jpg

Cheers

Lee



Sent from my iPhone using Tapatalk

johnnyb
13-02-2016, 06:35 PM
Rev the bike, slip the clutch and hope it's better than the guys around you. That's the science behind my starts


Sent from my iPhone using Tapatalk

Leezx10r
13-02-2016, 06:55 PM
Rev the bike, slip the clutch and hope it's better than the guys around you. That's the science behind my starts


Sent from my iPhone using Tapatalk

And it works well for you also Johnny [emoji106]🏻


Sent from my iPhone using Tapatalk

Turbo
13-02-2016, 07:06 PM
Wow!! Looks impressive, Lee.
What's the symptoms/negatives of launching at the moment?

zoidberg
13-02-2016, 07:16 PM
Rev the bike, slip the clutch and hope it's better than the guys around you. That's the science behind my starts


Sent from my iPhone using Tapatalk

Mine is very similar to yours Johnny, except you have skipped a couple steps of mine; <close eyes, scream in terror> they fit between rev the bike and slip the clutch.

Leezx10r
13-02-2016, 07:18 PM
Wow!! Looks impressive, Lee.
What's the symptoms/negatives of launching at the moment?

I think its lack of practice and setup opportunity.

The few I have tried started with massive wheelie (needed new undies) then went to extreme on the consecrative side, and could have jogged faster.

So it getting the correct launch rpm, ramp time, etc.

Thought that if anyone was using the software they could help out with a good setup.



Sent from my iPhone using Tapatalk

Turbo
13-02-2016, 07:25 PM
So, the ramp doesn't start until 67Km/h then it does it for 1.75 seconds every shift?
Would a slightly longer hold time not help with the wheelie? Then ramp up after that speed?

Leezx10r
13-02-2016, 07:42 PM
So, the ramp doesn't start until 67Km/h then it does it for 1.75 seconds every shift?
Would a slightly longer hold time not help with the wheelie? Then ramp up after that speed?

Just first gear then goes back into silly mode lol
But yes a longer hold would help, but as its "steady" increase to limit, the ramp time helps keep front end down plus wheelie control.
I think you can see why I was looking for a map, or a good day of setup as there's loads of combinations, but I will work it out

Turbo
13-02-2016, 07:45 PM
Yeah, totally. I think in the absence of a friendly map, trial and error is gonna have to be the way to go..

Leezx10r
13-02-2016, 07:58 PM
Yeah, totally. I think in the absence of a friendly map, trial and error is gonna have to be the way to go..

Time to find a setup location [emoji965][emoji106]

Marshy
13-02-2016, 08:04 PM
Time to find a setup location [emoji965][emoji106]

ARDC private practice. You can practice starts all day if you want to.

chubb
13-02-2016, 09:09 PM
7000 is good launch rpm. Why is your hold time 250? Ideally should be at 100. Are you slipping the clutch too much?

You want to calculate how long it takes you to get to redline from when you release the clutch. That is how long you should set your ramp to.

What is 1st gear speed based on your gearing at 7000? Ramp start speed should be just below that

chubb
13-02-2016, 09:20 PM
Should look like this


http://www.youtube.com/watch?v=j5Hy1RKbOoI

Baddie
13-02-2016, 09:28 PM
Lee there a bloke on the zx10r.net site called ZX10RArcher always happy to help and theres a shitload of racers that well help as well..

http://www.zx-10r.net/

Leezx10r
14-02-2016, 08:09 AM
7000 is good launch rpm. Why is your hold time 250? Ideally should be at 100. Are you slipping the clutch too much?

You want to calculate how long it takes you to get to redline from when you release the clutch. That is how long you should set your ramp to.

What is 1st gear speed based on your gearing at 7000? Ramp start speed should be just below that

Thanks mate, that's great just send you a pm [emoji106]🏻


Sent from my iPhone using Tapatalk

Leezx10r
14-02-2016, 08:19 AM
ARDC private practice. You can practice starts all day if you want to.

Is that just leaving pit lane or can you "go round the back?" But am there on the 1st Nick


Lee there a bloke on the zx10r.net site called ZX10RArcher always happy to help and theres a shitload of racers that well help as well..

http://www.zx-10r.net/

I will join and have read, thanks mate will be a rocket when I get it dialled in


Sent from my iPhone using Tapatalk